Step by step operations

1. Place the mixer on the bench
2. Remove the propeller
3. Extract the split pins and remove the sliding cylinders
4. Remove the handle
5. Remove the runner
6. Remove the plastic guard from the runner
7. Remove the bracket
8. Lie the motor on the bench and unscrew the cap of the oil chamber
9. Drain the oil from the chamber into a suitable container and dispose of it
10. Stand the motor on the bench
11. Remove the cable gland
12. Remove the motor cover
13. Remove the ground connection screw
14. Cut the cables of the stator, the thermal protections and the sensor
15. Remove the cable stop and extract the cable from the motor cover
16. Remove the O-ring
17. Remove the rubber gasket and cable gland
18. Extract the top bearing support with the aid of two suitable screws
19. Overturn the motor
20. Undo the screws of the pump plate and remove it
21. Extract the counterface and O-ring from the pump plate
22. Remove the second mechanical seal
23. Remove the snap ring
24. Remove the first mechanical seal
25. Remove the snap ring and extract the bushing
26. Remove the snap ring and O-ring
27. Unscrew the cable gland and extract the sensor and rubber gasket
28. Extract the drive shaft with the aid of a press
29. Remove the bearing and the washer
30. Fit the extractor plate (use the appropriate model for the motor)
31. Fit the press with a driver suitable to support the case and allow extraction of the stator
32. Place paper or rags underneath to cushion its fall
33. Place the cables inside the stator and place the case on the driver
34. Remove the stator
35. Using an extractor, remove the top bearing